
Heavy power transformers
Power that industry
can build on.
Oil-immersed and cast resin transformers engineered to your duty cycle, manufactured to IEC standards and tested unit by unit before dispatch.
- Engineered to order
- Routine tested
- IEC / EN compliant
Nameplate
Series OH
2,500kVA
Hermetically sealed · ONAN
- Voltage
- 11 / 0.4 kV
- Winding
- Copper
- Standard
- IEC 60076
- Status
- Routine tested
REF. PS-OH-2500 · DESIGNED IN-HOUSE
25,000kVA
Maximum rating
36kV
Insulation class
100%
Routine tested
7yrs
Engineering experience
The product range
Transformers for every link in the power chain.
From compact distribution units to engineered 25 MVA power transformers. Every platform can be adapted for voltage ratio, losses, cooling, enclosure and site conditions.

From the works
Every unit is routine tested before it leaves our floor.
Ratio, losses, impedance, applied and induced voltage, partial discharge.
Why Polystar
Built around your duty cycle — not a catalogue.
Standard units rarely fit every site. We start with your load profile, fault level and physical constraints, then tune the electrical and thermal design to match. The result is a transformer that fits the first time — with no surprises at commissioning.
Loss optimisation
Designs balanced for capital cost and lifecycle energy use.
Dimensional fit
Tank, bushings and cable positions matched to your room.
Difficult duties
Harmonic-rich loads, dual voltage and high ambient.
Documented quality
Test records, drawings and material certificates.
What we do
One team, from first sketch to final test.
Engineering, manufacture and testing sit under one roof. That means fewer hand-offs, faster answers and direct accountability for the finished unit.
Custom design engineering
Losses, impedance, tapping, noise and dimensions developed around your single-line diagram and site constraints.
Winding & core manufacture
Copper or aluminium windings, step-lap cores and controlled clamping for mechanical strength under fault conditions.
Tank fabrication & oil processing
Corrugated and conservator tanks, leak testing, vacuum oil filling and sealed-for-life assembly.
Routine & type testing
Ratio, losses, impedance, dielectric and partial discharge tests on every unit, with type tests available.
Factory acceptance
Documented test records and customer-witnessed FAT, with special tests including heat run and impulse.
Lifecycle support
Spares, condition assessment, oil analysis guidance, retrofits and commissioning support after handover.
Where we work
Powering the sectors that cannot stop.
Different loads demand different transformer behaviour. We specify for the way your site actually runs.
Utilities & grid
Distribution and substation transformers with predictable losses and a service life measured in decades.
Manufacturing
Robust units for continuous process loads, large motors and heavy multi-shift operations.
Data centres
Fire-safe cast resin units with low noise, tight regulation and high availability.
Renewables
Custom ratios and impedances for wind, solar and battery storage interconnections.
Mining & metals
High-duty designs for dusty, high-ambient and remote environments with limited maintenance access.
Infrastructure
Compact, dependable power for transport, water treatment and public works projects.
How it works
A clear route from enquiry to energisation.
One engineering contact, a documented design and a test plan agreed before manufacture starts.
Specify
Share your single-line diagram, load profile and site constraints. We review the duty with you.
Engineer
Winding, core, insulation and cooling are designed and modelled against your specification.
Build & test
Manufacture, routine testing and a documented factory acceptance review before dispatch.
Deliver & support
Transport planning, installation guidance, commissioning support and lifecycle spares.
Start a project
Send us your specification. We'll engineer the rest.
A single-line diagram is enough to start. Our team will come back with a buildable design, expected losses and a firm price.



